| Step | | Procedure & Parts & Tools |
| 1 |
|
TURN THE KEY OFF AND LOCATE CHARGER PLUG ON BACK OF MACHINE AND PULL IT TO DISCONNECT THE BATTERIES.
|
| 2 |
|
PULL TO REMOVE THE RED CAPPED HOSE FROM MACHINE. PLACE HOSE NEAR DRAIN AND REMOVE CAP
|
| 3 |
|
PULL TO REMOVE THE BLUE CAPPED HOSE FROM MACHINE. PLACE HOSE NEAR DRAIN AND REMOVE CAP.
|
| 4 |
|
REMOVE THE 2 TANK BOLTS ON EACH SIDE OF THE MACHINE. THESE BOLTS ARE LOCATED AT THE FRONT OF THE MACHINE AT THE BASE. LIFT THE TANK TO OPEN THE MACHINE.
| Wrench-Allen metric 6.0mm |
|
|
| 5 |
|
REMOVE THE 2 SHROUD BOLTS ON EACH SIDE OF THE MACHINE
| Wrench-Allen metric 6.0mm |
|
|
| 6 |
|
REMOVE THE 3 BOLTS HOLDING THE BRUSH MOTOR
| Wrench-metric 10mm |
|
|
| 7 |
|
PULL UP ON THE BRUSH MOTOR TO REMOVE IT FROM THE MACHINE
|
| 8 |
|
REMOVE THE 6 SCREWS HOLDING THE CONTROL PANEL.
| Screwdriver-phillips |
|
|
| 9 |
|
REMOVE THE CONTROL PANEL FROM THE MACHINE.
|
| 10 |
|
LOCATE THE BLACK BRUSH MOTOR PLUG. UNPLUG IT FROM THE CONTROL PANEL. THREAD THE WIRE THRU THE HANDLE AND DOWN TO THE BRUSH MOTOR TO FREE THE BRUSH MOTOR FROM THE MACHINE.
|
| 11 |
|
REVERSE STEPS 1 THRU 10 TO REPLACE THE VAC MOTOR.
|